Gary
Amazon.in10 Sept 2021
up date from my last review on esun white 3d printer filament
the prints i looked at real close were my go to test prints and they were quite smooth where needed to be and detailed where they were suppose to be, possibly attributed to the filament or is it my programming, lets go with both, either way i am pleased and would recommend to anyone well at least the PLA+ white since that is all i have tried so far, the only other thing that i found that might be a bit of a concern is the fact that as the gets used up and there is less on the spool that the diameter of the filament gets less. It started out at a majority of where i measured at 1.74 to 1.76 mm and at about mid roll it was holding steady at around 1.73mm to 1.74mm which is close to the advertised diameter, but at the end the last 100 feet or so maybe more it was 1.60mm to 1.68mm and measured jumping around between the two quite consistently so depending on where that started could effect your print but it sure changes the cost of the spool as far as what its sold for in comparison to what it cost to make. anyway thats my review Read more Read less











