Navraj Thapa
Amazon.in10 Jan 2022
Lives up to its name. [UPDATED: Good for laptops too]
UPDATE: Used it to re-paste my old laptop. Considering it gives out more heat now during load operations, I'm assuming it's working great. But then again, my laptop is more than a decade old so....yeah. Summer temperatures update: Alright. Summers are here in full effect. Ambient temperatures here in Dehradun are around 38° C average. Nowadays, the idle temperatures range between 50° to 55° C. Under full load when stress testing, maximum obtained temperatures were always around 80° to 82° C. When rendering videos in both Adobe Premiere Pro and After Effects, it averages around 75° to 80°C. And during gaming, temperatures never go past 72° C. Yeah....the temperatures have risen considerably now, compared to winters and spring, however I'm just using a budget air cooler, so it is still decent. Also, it's still better than what I used to get with the stock cooler and paste (+95° C on full load and +82° C when gaming). Also, my only exhaust fan died too, so there's that as well. I'll be upgrading my cooler, fans and maybe cabinet too, sooner or later, so maybe I'll post a third temperatures update here. This thermal paste lives up to its name. I personally used it for repasting my desktop. The processor is AMD Ryzen 5 3600, paired with a Cooler Master Hyper H410R RGB CPU Cooler. Even in the heaviest benchmark loads, temperatures never crossed 69° C (nice 😀). On idle, I get around between 30° to 40° C and between 55° to 63° C at the most when gaming. These are winter season temperatures, by the way. I'll update the summer season temperatures too. As for applying the thermal paste, it might get a little difficult first time, so I'd recommend watching some good application tutorials. The paste, in good conditions, is neither too liquidy nor too solid. Simply put, make sure to clean off the old thermal paste using +90% isopropyl alcohol, then just apply a dot of the thermal paste in the middle of your processor's TIM: around 2-3mm in diameter for Intel processors and around 4-5 mm in diameter for AMD processors, then mount your cooler. DON'T PUT TOO MUCH THERMAL PASTE. It's easy to get overboard. Don't be alarmed if the temperatures, immediately after repasting, aren't desirable or even higher than before. Thermal pastes have a specific cure-in time to spread and set properly, so continue using your PC as normal and the temperatures should normalise eventually; considering if you were sure the paste was in good condition and you didn't mess up both repasting and cooler mounting procedures. In my opinion, it's worth the Rs. 617 I paid for. Read more Read less














